Hello everyone! Like I promised I am sharing with you the inspiration behind the airport warp in creative that you all know and love! As a kid I have done a LOT of flying mostly domestically and a little international. From a young age because I would fly a lot I became fascinated with how airports run and all of the technical aspects of running an airport. When I was a little bit older and able to comprehend a little bit more I became fascinated with the different types of aircraft that are produced. There are 3 major aircraft manufacturers in the U.S. They are Airbus, Boeing, and Bombardier. I soon went deeper into the specifics of differences in similar models for example the difference between a Boeing 737-700 and a Boeing 737-800. I also observed that you cant tell for the most part what model plane your looking at from seeing the exterior of the plane. The one exception is Southwest Airlines which only used Boeing 737-700s and Boeing 737-800s. On the Southwest planes the 737-700 has 1 emergency exit over each wing, 2 total over wing emergency exits. In the 737-800 there are 2 over wing exits per wing so 4 total over wing emergency exits. If you dont understand that here is a picture of the Boeing 737-700 and Boeing 737-800 from Southwest below attached to this post. The first one is the 737-700 and the one below is the 737-800.
This has been an exclusive behind the scenes interview of rtd321.
Thanks for reading this post! See you all on Cubebuilders!
Sincerely,
rtd321